35
10.4.4 Check Function priority rules for dual platform (PA) operation
Instrument follows the below priority rule numbers to determine the Lo and Hi check limits for dual platform
(PA) operation.
1.
The platform with larger capacity.
2.
The platform with larger division value.
3.
P1 when both platforms have the identical capacity and division settings.
10.5 Memory Accumulation
Below memory accumulation modes are available for each UART port: -
a.
Memory accumulation disabled.
b.
Manual accumulation.
c.
Automatic accumulation.
Notes: -
•
During counting operation, both net weight and piece value will be accumulated.
•
Date stored will not be erased when powered off.
•
Data stored will be erased when operator number is changed.
10.5.1 Memory accumulation settings
To enable/disable memory accumulation, an UART should be set to one of the following modes: - Auto 1; Auto
2; Auto 3; Manual.
•
To enable memory accumulation, set Auto Accumulation to On in internal function number F16.
•
To disable memory accumulation, set Auto Accumulation to Off in internal function number F16.
Refer to step
4
of paragraph
8.3
for setting details.
10.5.2 Manual accumulation
Press
[Print/M+]
to accumulate the current value to memory.
10.5.3 Automatic accumulation
12
Automatically memory accumulation of an UART is activated when
Auto Accumulation
is set to
On
in Auto 1,
Auto 2, Auto 3. Under the automatic accumulation mode, corresponding results will be accumulated.
Unstable results or results which are less than 20d (or 20d
1
for dual weighing range/interval mode) will not be
accumulated.
10.5.4 When data is accumulated to memory
When a result is accumulated to memory: -
•
Instrument displays “
n____x
” on LCD3.
•
M+ Indicator
appears to indicate that memory contains stored data. “x” means the total number of
transactions accumulated to memory.
•
This instrument returns to normal display status after 2 seconds.
12
Auto 1 ~ 3 do not support PA.
