49
21.2.2 Barcode scanner method
1.
In F37, make sure that the proper code is set to On. i.e.,: -
If a Production Settings PLU is recalled by customer code, then C Code in F37 should be set to
On.
If a Production Settings PLU is recalled by product code, then P Code in F37 should be set to On.
2.
At Weighing mode, select the desired weight unit.
3.
Scan the barcode, which contains the desired customer or product code.
4.
The Production Settings PLU of the code scanned is now recalled, and the
Production Settings PLU
Indicator
appears.
5.
To shift to another Production Settings PLU, repeat above steps 1 ~ 3.
Note
: When the customer/product code scanned does not exist in any Production Settings PLUs,
Production
Settings PLU Indicator
will not appear.
21.2.3 Computer command method
Refer to
Appendix V
for more information.
21.3 New Code Scanned/Inputted when a Production Settings PLU is Running
21.3.1 In case new customer/product code is by barcode scanner
Refer to paragraph
20
in case a new code is scanned when a Production Settings PLU is running.
21.3.2 In case new code/description is inputted by keyboard
1.
Production Settings Indicator
disappears.
2.
All settings of the last Production Settings PLU used remain valid except for the new code/description
inputted.
21.4 To quit from the Current Production Settings PLU.
21.4.1 Keyboard Method
1.
Input
00
for PLU number at step 4 of paragraph
21.2.1
.
2.
Production Settings PLU Indicator disappears, and all operation settings become default ones.
21.4.2 Scanner method
Scanner method does not quit completely the current production PLU setting
To quit completely the current production PLU settings, use the keyboard method as per paragraph
21.4.1
.
22. Commands
The following types of command are available: -
a.
Keyboard commands are used to simulate key entries on keyboard.
b.
Execution commands are used to execute an action.
c.
System parameter & operation entry setting commands are used to send system parameters and
operation entries to this instrument.
d.
System parameter reading commands are used to read system parameters.
e.
Operation entry reading commands are used to read those operation information inputted (e.g., date,
time, product, and customer codes), current and accumulated operation results.
f.
Operation result reading commands are used to read current and accumulated operation results.
