2 - 13
Installation Procedures
Front Panel Block and Speaker Connector
This block connector includes the connectors for linking with HDD LED,
power LED, dual power LED, power button, suspend button, reset button, and
IR on the front panel of the system case. Please identify polarities of plug
wires for the case speaker and LEDs. Please ask vendor about this information
when you buy them and install the system by yourself. The plug wires polari-
ties of these buttons will not affect the function.
Power LED
is connected with the system power indicator to indicate whether
the system is on/off. It will blink when the system enters suspend mode.
IR
is used to communicate with another IR device via a 4-wire plug.
Reset Button
is connected to the reset button. Push this switch to reboot the
system instead of turning the power button off and on.
HDD LED
is connected to the IDE device indicator. This LED will blink when
the hard disk drives are activated.
LED(G)
is in green light when the system in power on status.
LED(Y)
is in yellow light when the system in suspend mode.
Power Button
is connected with power button. Push this switch allows the
system to be turned on and off rather than using the power supply button.
Suspend Button
is connected with suspend button. To enter the system into
power saving mode, simply press this button when the system is in full-on
mode.
Speaker
is connected with the case speaker.