Operating instructions WPM Gateway IoT
19/76
Commissioning
5.1.2
Commissioning the WPM Gateway
After the network settings have been set up on the PC, the WPM Gateway can be put into op-
eration.
1) Connect the WPM Gateway to the power supply via the power supply unit.
2) Connect the WPM Gateway to the PC via a LAN cable.
3) Open the Web browser and enter the IP address http://10.10.10.10 of the WPM Gateway
specified in the network setting.
4) When access for the first time, the WPM Gateway Administrator must be set up.
–
Enter the email address of the Administrator.
–
Enter the password of the Administrator.
Fig. 5-2 Commissioning the WPM Gateway
With the WPM GatewayAdministrator account, additional users with different permissions can
then be set up on the web interface of the WOM Gateway (see Chapter 6.1 "Create users" on
page 24).
WPM devices (sensors and data holders) that are within range of the WPM Gateway should be
visible.
To enable the full functionality, a WPM Gateway license must be applied for under the Adminis-
tration menu item (see Applying for a new license in Chapter 9.1.1 "License and license key" on
page 55).
The WPM Gateway must be set to the correct time in order for the recorded data to be usable
(see Chapter 5.1.3 "Setting the time" on page 20).
1
2
3
4
http://10.10.10.10
Set up gateway
Please create your initial gateway administrator
Password
Confirm Password
New Tab
Create user
