Reproduction forbidden without Fibocom Wireless Inc. written authorization - All Rights Reserved
FIBOCOM L610 Series Hardware Guide
Page 30 of 59
Parameter Mode
Condition
Average Typ.Current
(mA)
DCS1800 PCL0
200
PCS1900 PCL0
200
I
GPRS-RMS
CS4
GPRS
GPRS Data transfer GSM850; PCL=5; 1Rx/4Tx
480
GPRS Data transfer GSM900; PCL=5; 1Rx/4Tx
480
GPRS Data transfer DCS1800; PCL=0; 1Rx/4Tx
400
GPRS Data transfer PCS1900; PCL=0; 1Rx/4Tx
400
I
LTE-RMS
LTE FDD
LTE FDD Data transfer Band 1 @+23dBm
730
LTE FDD Data transfer Band 2 @+23dBm
780
LTE FDD Data transfer Band 3 @+23dBm
730
LTE FDD Data transfer Band 4 @+23dBm
730
LTE FDD Data transfer Band 5 @+23dBm
600
LTE FDD Data transfer Band 7 @+23dBm
730
LTE FDD Data transfer Band 8 @+23dBm
600
LTE FDD Data transfer Band 20 @+23dBm
600
LTE FDD Data transfer Band 28 @+23dBm
600
LTE FDD Data transfer Band 66 @+23dBm
730
LTE TDD
LTE TDD Data transfer Band 34 @+23dBm
350
LTE TDD Data transfer Band 38 @+23dBm
400
LTE TDD Data transfer Band 39 @+23dBm
350
LTE TDD Data transfer Band 40 @+23dBm
400
LTE TDD Data transfer Band 41 @+23dBm
400
3.3 Control Signal
L610 modules provide two control signals for power on/off and reset operations. The pin definitions are as
follows:
Pin Name I/O Pin
Description
RESET_N I
20
When the module is in work, pull down RESET for Tst (100ms), and then
pull it high, the module is reset
PWRKEY I
21
When pulling down for power on, the minimum duration of low level is 2s;