79-15169-00 Rev. A
http://www.fiberstars.com
Page 1 of 4
WPCRMR
WPC REMOTE RECEIVER
FOR WPC1 AND WPC2 INSTALLATIONS
The WPCRMR is shipped with a label indicating the Channel Code. Check the Channel Code with the Channel
Code on the Remote Control. If the Codes do not match, it will be necessary to change the transmission code on
the WPCRMR AND/OR the WPC transmitter.
TRANSMITTER DIP SWITCHES – Remove all screws from rear of remote. Separate the bottom cover from the
top cover. Ensure that the rubber gasket does not come off of the receiver. Locate the DIP switch as illustrated
below. Change the DIP switches according to the illustration below. Reassemble the transmitter in reverse order
of disassembly. When tightening screws, ensure that they are all finger tight first. Then gradually tighten the
screws until they are snug. Over-tightening will damage the receiver enclosure and may allow moisture to seep
inside.
RECEIVER DIP SWITCHES –
NOTE: IF CHANGING CHANNEL CODE ON RECEIVER, PERFORM
CHANNEL CHANGE BEFORE INSTALLING INTO THE WPC UNIT.
Unscrew the four (4) screws
located on the back of the receiver to release the cover. NOTE: Take notice of how the wires enter and exit the
receiver. Remove the cover and look on the PCB to locate the DIP switch as illustrated. Change the DIP switches
according to the illustration below. Reassemble the receiver in reverse order of disassembly.
NOTE: The four DIP switches have an ON and an OFF position. Changing just one DIP switch will change
the code. MAKE SURE BOTH THE RECEIVER AND TRANSMITTER HAVE THE SAME DIP
SWITCH SETTINGS.
Receiver
screws
DIP switch
DIP Switch
Rear screws
1
5
9
13
2
6
10 14
3
7
11 15
4
8
12 16
CHANNEL
DIP Switch
DIP SWIT CH
1
2
3
4
Channel 1
OFF
OFF
OFF
OFF
Channel 2
ON
OFF
OFF
OFF
Channel 3
OFF
ON
OFF
OFF
Channel 4
ON
ON
OFF
OFF
Channel 5
OFF
OFF
ON
OFF
Channel 6
ON
OFF
ON
OFF
Channel 7
OFF
ON
ON
OFF
Channel 8
ON
ON
ON
OFF
Channel 9
OFF
OFF
OFF
ON
Channel 10
ON
OFF
OFF
ON
Channel 11
OFF
ON
OFF
ON
Channel 12
ON
ON
OFF
ON
Channel 13
OFF
OFF
ON
ON
Channel 14
ON
OFF
ON
ON
Channel 15
OFF
ON
ON
ON
Channel 16
ON
ON
ON
ON
Note: Sample shown is of Channel 9