15
operatIng the DevIce
• 3 red blinks – entering the menu (not added to a Z-Wave network),
• Green – reset energy consumption memory,
• Magenta – start Z-Wave range test,
• Yellow – reset to factory defaults,
• White – change or check operating mode (single or double switch),
• 1 white blink – single switch mode,
• 2 white blinks – double switch mode.
7.5:
Menu
Menu
allows to perform Z-Wave network actions. In order to use the
menu:
1. Quickly, three times click, then press and hold one of the buttons
to enter the menu, device blinks to signal adding status (see 7.4:
2. Release the button when device signals desired position with
colour:
•
WHITE
– change or check single/double switch mode
•
GREEN
– reset energy consumption memory
•
MAGENTA
– start Z-Wave range test
•
YELLOW
– reset to factory defaults
3. Quickly click the button to confirm.
7.6:
Resetting to factory defaults
Reset procedure allows to restore the device back to its factory set-
tings, which means all information about the Z-Wave controller and
user configuration will be deleted.
i
Resetting the device is not the recommended way of
removing the device from the Z-Wave network. Use re-
set procedure only if the primary controller is missing or
inoperable. Certain device removal can be achieved by the
procedure of removing described.
1. Quickly, three times click, then press and hold one of the buttons
to enter the menu.
2. Release button when the device glows yellow.
3. Quickly click the button to confirm.
4. After few seconds the device will be restarted, which is signalled
with red LED colour.
