4
BASIC ACTIVATION
#2: Basic activation
CAUTION
Install the device in
horizontal
position
only!
!
CAUTION
Do not cover or veil the
thermostatic head.
!
1. Connect the charger to the micro-USB port to charge the device.
If you have the temperature sensor:
a. Use a coin to open the battery cover by turning it coun-
ter-clockwise.
b. Remove the sticker underneath the battery.
c. Use a coin to close the battery cover by turning it clockwise.
2. Disconnect the charger when the LED ring pulses green (device
fully charged).
3. Dismount your current thermostatic head.
4. Depending on type of your thermostatic valve:
5. Mount the device on the valve and tighten it by turning the cap
clockwise.
6. Use the included key to click the button.
7. The LED ring will start blinking blue.
If you have the temperature sensor:
a. Click the button on it now.
b. The LED ring will blink green 5 times
if the connection was successful.
M30 x 1.5
Danfoss RTD-N
Danfoss RA-N
Proceed normally
Use adapter:
Use adapter:
NOTE
First charging may take
up to 3 hours.
i
