11
aDDIng to Z-Wave netWork
5:
Adding to Z-Wave network
Adding (Inclusion)
– Z-Wave device learning mode, allowing to add
the device to existing Z-Wave network.
i
Full DSK code is present only on the box, make sure to
keep it or copy the code.
5.1:
Adding manually
To add the device to the Z-Wave network
manually
:
1. Power the device.
2. Set the main controller in (Security/non-Security Mode) add mode
(see the controller’s manual).
3. Quickly, three times click the service button.
4. If you are adding in Security S2 Authenticated, input the underlined
part of the DSK (label on the box).
5. LED will start blinking yellow, wait for the adding process to end.
6. Adding result will be confirmed by the Z-Wave controller’s message
and the LED:
•
Green
– successful (non-secure, S0, S2 Unauthenticated),
•
Magenta
– successful (Security S2 Authenticated),
•
Red
– not successful.