12
operatIng the DevIce
• Blinking magenta – entering the menu (added as Security S2
Authenticated),
• Blinking red – entering the menu (not added to a Z-Wave network),
• Magenta – test Z-Wave network range,
• Yellow – reset to factory defaults.
7.3:
Menu
Menu
allows to perform Z-Wave network actions. In order to use the
menu:
1. Press and hold the maintenance button to enter the menu.
2. LED will signal adding status for 3 seconds (see 7.2: Visual
indications), then turn off for another 3 seconds.
3. Release the button when device signals desired position with
colour:
•
Magenta
– test Z-Wave network range
•
Yellow
– reset to factory defaults
4. Quickly click the button to confirm.
7.4:
Resetting to factory defaults
Reset procedure allows to restore the device back to its factory set-
tings, which means all information about the Z-Wave controller and
user configuration will be deleted.
!
Make sure that restoring the parameters to factory
defaults will not result in damaging the connected
device, we recommend disconnecting it first.
i
Resetting the device is not the recommended way of
removing the device from the Z-Wave network. Use re-
set procedure only if the primary controller is missing or
inoperable. Certain device removal can be achieved by the
procedure of removing described.
1. Press and hold the maintenance button to enter the menu.
2. Release button when the device glows yellow.
3. Quickly click the button to confirm.
4. After few seconds the device will be restarted, which is signalled
with red LED colour.
