16
GETTING TO KNOW YOUR VEHICLE
After placing the ignition switch in the ON/RUN
position, the vehicle security light will turn on for
three seconds for a bulb check. If the light
remains on after the bulb check, it indicates
that there is a problem with the electronics. In
addition, if the light begins to flash after the
bulb check, it indicates that someone used an
invalid key fob to start the engine. Either of
these conditions will result in the engine being
shut off after two seconds.
If the vehicle security light turns on during
normal vehicle operation (vehicle running for
longer than 10 seconds), it indicates that there
is a fault in the electronics. Should this occur,
have the vehicle serviced as soon as possible by
an authorized dealer.
All of the key fobs provided with your new
vehicle have been programmed to the vehicle
IGNITION SWITCH
K
EYLESS
E
NTER
-N-G
O
— I
GNITION
This feature allows the driver to operate the
ignition switch with the push of a button as long
as the key fob is in the passenger compartment.
The START/STOP ignition button has three
operating modes. These modes are OFF, ON,
and RUN.
START/STOP Ignition Button
The push button ignition can be placed in the
following positions:
OFF
The engine is stopped.
No electrical devices are available.
ON
The vehicle is not running.
Some electrical devices (central locking,
alarm, etc.) are still available.
RUN
Driving mode.
All the electrical devices are available (e.g.
climate controls, heated seats, etc).
NOTE:
The vehicle will not start if the key fob is located
inside the cargo area and the liftgate is opened.
Backup Starting Method
CAUTION!
The Sentry Key Immobilizer system is not
compatible with some aftermarket remote
starting systems. Use of these systems may
result in vehicle starting problems and loss of
security protection.
21_FD_OM_EN_USC_t.book Page 16
