Fiat 500X 2019, Owner'S Manual

Page: 244 / 468

•
The braking temperature exceeds normal range (over-
heated).
•
The Electronic Stability Control/Traction Control Sys-
tem (ESC/TCS) activates.
•
The vehicle parking brake is applied.
•
The driver switches ESC to full-off mode.
To Turn Off
The system will turn off and clear the set speed in memory
if:
•
The Adaptive Cruise Control (ACC) on/off button is
pushed.
•
The Normal (Fixed Speed) Cruise Control on/off button
is pushed.
•
The ignition is turned OFF.
To Resume
If there is a set speed in the memory, push the RES button
and then remove your foot from the accelerator pedal. The
instrument cluster display will show the last set speed.
WARNING!
The Resume function should only be used if traffic
and road conditions permit. Resuming a set speed that
is too high or too low for prevailing traffic and road
conditions could cause the vehicle to accelerate or
decelerate too sharply for safe operation. Failure to
follow these warnings can result in a collision and
death or serious personal injury.
To Vary The Speed Setting
To Increase Speed
While ACC is set, you can increase the set speed by
pushing the SET
(+) button.
The driver’s preferred units can be selected through the
instrument panel settings if equipped. Refer to “Getting To
Know Your Instrument Panel” for more information. The
speed increment shown is dependant on the chosen speed
unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
•
Pushing the SET (+) button once will result in a 1 mph
increase in set speed. Each subsequent tap of the button
results in an increase of 1 mph.
242 STARTING AND OPERATING