8. Reinstall the gear selector boot.
FREEING A STUCK VEHICLE
If your vehicle becomes stuck in mud, sand or snow, it can
often be moved using a rocking motion. Turn the steering
wheel right and left to clear the area around the front
wheels. Push and hold the lock button on the gear selector.
Then, shift back and forth between DRIVE and REVERSE,
while gently pressing the accelerator. Use the least amount
of accelerator pedal pressure that will maintain the rocking
motion, without spinning the wheels, or racing the engine.
NOTE:
Push the
⬙
ESC Off
⬙
switch, to place the Electronic
Stability Control (ESC) system in
⬙
Partial Off
⬙
mode, before
rocking the vehicle. Refer to “Electronic Brake Control
System” in “Safety” for further information. Once the
vehicle has been freed, push the
⬙
ESC Off
⬙
switch again to
restore
⬙
ESC On
⬙
mode.
WARNING!
Fast spinning tires can be dangerous. Forces generated
by excessive wheel speeds may cause damage, or even
failure, of the axle and tires. A tire could explode and
injure someone. Do not spin your vehicle’s wheels
faster than 30 mph (48 km/h) or for longer than 30
seconds continuously without stopping when you are
stuck and do not let anyone near a spinning wheel, no
matter what the speed.
CAUTION!
•
Racing the engine or spinning the wheels may lead
to transmission overheating and failure. Allow the
(Continued)
Gear Selector Override
1 — Raised Gear Selector Boot
2 — Gear Selector Override Access Hole
234
IN CASE OF EMERGENCY
Summary of Contents for 500L2018
