Fiat 500 L 2019, User Manual

Page: 37 / 172

Reprogramming A Single HomeLink Button
To reprogram a single HomeLink button that has
been previously trained, without erasing all the
channels, follow the procedure below
.
Be sure to
determine whether the new device you want to
program the HomeLink button to has a Rolling
Code, or Non-rolling Code
.
1
.
Cycle the ignition to the ON/RUN position,
without starting the engine
.
2 . Push and hold the desired HomeLink button
until the HomeLink Indicator light begins to
flash after 20 seconds
.
Do not release the
button.
3 . Without releasing the button , proceed with
Step 2 in “Programming HomeLink To A
Garage Door Opener” and follow all remain-
ing steps
.
General Information
The following regulatory statement applies to all
Radio Frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Innovation, Science and Economic
Development Canada license-exempt RSS stan-
dard(s)
. Operation is subject to the following two
conditions:
1
.
This device may not cause harmful interfer-
ence, and
2 . This device must accept any interference re-
ceived, including interference that may cause
undesired operation
.
NOTE:
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user’s authority to operate the equip-
ment
.
INTERNAL EQUIPMENT
Power Outlets
Passenger Compartment Power Outlet
The power outlet is located on the instrument
panel, below the climate controls
. It only operates
with the ignition key at MAR/ON .
On models with optional "smoker’s kit," the cigar
lighter takes the place of the power socket
.
Refer
to “Cigar Lighter” in this section for further
information
.
Passenger Compartment Power Outlet
35