Recirculation
In cold weather, use of Recirculation mode may
lead to excessive window fogging
.
The Recircula-
tion feature may be unavailable if conditions exist
that could create fogging on the inside of the
windshield
.
Automatic Temperature Control (ATC)
Automatic Operation
1
.
Push the AUTO button on the faceplate
.
2
.
Next, adjust the temperature you would like
the system to maintain by adjusting the tem-
perature control buttons
.
Once the desired
temperature is displayed, the system achieves
and automatically maintains that comfort level
.
3
.
When the system is set up for your comfort
level, it is not necessary to change the settings
.
You experience the greatest efficiency by
simply allowing the system to function
automatically
.
NOTE:
• It is not necessary to move the temperature
settings for cold or hot vehicles
.
The system
automatically adjusts the temperature, mode,
and blower speed to provide comfort as quickly
as possible
.
• The temperature can be displayed in U
.
S
.
or
Metric
units
by
selecting
the
US/Metric
customer-programmable feature
.
To provide you with maximum comfort in the
Automatic mode during cold start-ups, the
blower fan remains on low until the engine warms
up
.
The blower increases in speed and transition
into Auto mode
.
Manual Operation Override
This system offers a full complement of manual
override features
.
The AUTO symbol in the front
ATC display will be turned off when the system is
being used in the manual mode
.
NOTE:
The system will not automatically sense the
presence of fog, mist or ice on the windshield
.
Defrost mode must be manually selected to clear
the windshield and side glass
.
Operating Tips
Winter Operation
To ensure the best possible heater and defroster
performance, make sure the engine cooling sys-
tem is functioning properly and the proper
amount, type, and concentration of coolant is
used
.
Use of the Air Recirculation mode during
Winter months is not recommended, because it
may cause window fogging
.
Vacation/Storage
Before you store your vehicle, or keep it out of
service (i
.
e
.
, vacation) for two weeks or more, run
the air conditioning system at idle for about five
minutes, in fresh air with the blower setting on
high
.
This will ensure adequate system lubrication
to minimize the possibility of compressor damage
when the system is started again
.
If you are
leaving your vehicle dormant for more than four
weeks, disconnect the negative cable from the
battery
.
Refer to “Jump Starting Procedures” in “In
Case Of Emergency” for further information
.
GETTING
T
O
KNO
W
Y
OUR
VEHICLE
26
Summary of Contents for 500 L 2019
