Fiat 500 ABARTH CABRIO 2017, User Manual

Page: 107 / 172

ESC Full Off
This mode is intended for off-highway or off-road use only and should not be used
on public roadways. In this mode, all TCS and ESC stability features are turned
OFF, except for the limited slip feature described in the TCS section. To enter the
“Full Off” mode, push and hold the ESC OFF switch for five seconds. After five sec-
onds, the ESC OFF Indicator Light will illuminate, and the “ESC OFF” message will
display in the instrument cluster display. To turn ESC ON again, momentarily push
the ESC OFF switch.
— Park/Headlight ON Indicator
This indicator will illuminate when the park lights or headlights are turned on.
— Power Steering System Warning
This light is used to manage the electrical warning of the EPS (Electric Power Steer-
ing System). When the ignition is turned to the ON/RUN position, the warning light
will illuminate momentarily. If the warning light stays on, cycle the ignition to the OFF
position and back to ON/RUN. If the warning light stays on, contact your authorized
dealer.
If the warning light switches on while driving, you may not have steering assistance.
Although it will still be possible to steer the car, the effort needed to operate the
steering wheel could be increased: contact an authorized dealer as soon as possible.
— Defroster Indicator
Indicates that defroster is on.
Change Engine Oil
Your vehicle is equipped with an engine oil change indicator system. The “Change
Engine Oil” message will flash in the instrument cluster display for approximately
10 seconds after a single chime has sounded to indicate the next scheduled oil
change interval. The engine oil change indicator system is duty cycle based, which
means the engine oil change interval may fluctuate, dependent upon your personal
driving style.
Unless reset, this message will continue to display each time you turn the ignition
switch to the ON/RUN position. To turn off the message temporarily, push and re-
lease the
MENU
button. To reset the oil change indicator system (after performing
the scheduled maintenance), refer to the following procedure:
1. Turn the ignition switch to the ON position (Do not start the engine).
2. Fully depress the accelerator pedal slowly, three times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this procedure.
WHAT TO DO IN EMERGENCIES
105