FHF InduTel IP, Operating Instructions Manual

Page: 8 / 48

8
2 General Notes on Operation
1. The InduTel IP is a VoIP (Voice over Internet Protocol) telephone and is oper-
ated on a 10/100 BaseT Ethernet network. The connections are established
via the Session Initiation Protocol (SIP).
2. The power supply may be established via Power over Ethernet (PoE) from the
network or via a separate direct current voltage source (see chapter 2.2.2).
3. The programming and parameter setting are carried out solely via the web
server of the telephone. The web server can be reached via the standard web
browser of a PC. In order to access the web server, entering the username
and the password is mandatory. The factory settings for the username and
password are:
Username: admin
Password: fhf
On default since software version 1.0 r8xx the device is working in the DHCP
client mode. If no DHCP server is available, then the device uses the preset IP
address 192.168.0.77 and mask 255.255.255.0.
4. The telephone has a handset rest with a magnetic contact as a hook switch.
In order to end an existing call, the handset must be hung up, or the cut-off
key (see chapter 2.3.1) on the keypad must be pressed.
5. The internal relay contacts only allow voltages of 30 VAC or 60 VDC to be
switched. The maximum permissible current depends on the mode of opera-
tion (see chapter 8).
6. The handset of the telephone is fitted with a stray field coil for connection to
hearing aids. Those who wear a hearing aid with an inductive receiver can re-
ceive the signal of the earphone capsule directly over the hearing aid.
2.1 At the Time of Delivery
Contents of the Packaging 2.1.1
 Telephone InduTel IP
 These operating instructions
 LAN device connector plug