FFS Brands Vizu 400 Pass Through Multi Stack, Manual

Page: 8 / 28

Page 8 of 28
Description of Multi Stack Auto Fill Pass Thu machines
The Multi Stack Auto Fill Pass Thru unit must only be used to keep cooked food hot and
moist; it must not be used to re-heat cooked foods.
The machine is suitable for holding cooked meats and fish.
This unit is more complex machine than a standard Pass-Thru and as such there are a few
more rules of use.
 When the machine is placed in the position that it will be used in it is important to
ensure that it is level. Ensure that the surface the Pass-Thru is mounted on is flat
and well supported.
 The machine can be either connected to a Mains water supply or the supplied water
tank (which must be refilled by the machine operator).
 The unit is supplied as standard with the remote water tank. The water pressure
reducing valve is pre-set, however if the location the machine is being installed in
has a different water pressure this may need to be adjusted.
 If the tank is to be re-positioned, OR mains feed is to be made the water feed
connection to the machine must be dis-connected. See Fig. 1 & Fig. 2 below.
Figure 1 Figure 2
 The standard plumbing fitting used for a washing machine can be fitted to the
remaining threaded piece shown in Fig 2
 The tank can be mounted on the opposite side of the unit if desired, alternatively the
tank can be placed on an up-stand or other location – If this is the case it is
important that the tank is NOT at a lower position than it would be if it were
mounted on the side of the machine, otherwise the water flow will be adversely
affected.