Page 22
Calibration Errors
An error may occur during the calibration process. Any error will be
displayed in the following format:
The error message will be displayed until the
OK
button is pressed
and is not subject to the usual 30-second timeout and the reason
for the error is also stored in the calibration log. If multiple errors
occur, they are displayed in sequence. Once the
OK
button has been
pressed for the last error message, the TalentumTT
2
will turn itself off.
Below is a list of the possible error messages, along with more detail
on their meaning:
• Shroud not fitted! Check the shroud
Check that the Shroud is fitted to the
TalentumTT
2
and the Flame
Detector correctly.
• Unable to connect to Talentum
The TalentumTT
2
cannot communicate successfully with the
Flame Detector. Check that the cable is correctly connected to
both the TalentumTT
2
and the Flame Detector maintenance port.
• Could not reset Talentum
The TalentumTT
2
cannot reset the Flame Detector. Again, check
that the cable is correctly connected and has not been damaged.
If it appears correct, the Flame Detector may need servicing.
ERROR
Could not read
Talentum version
Press OK to continue
