background image

TURNKEY® pins Installation and Removal, 

TURNKEY® Range.

Assembly instructions

Equipment 

: The use of the TK13OD tool is 

recommended for turnkey teeth assembly/

disassembly.

Always work safely and wear your safety 

equipment (hard hat, steel-toed shoes, 

gloves, safety glasses).

Keep bystanders away.

Cleaning 

: Tilt the bucket 30° upwards.

Before inserting turnkey sleeve in its hou-

sing, we recommend to clean the adapter 

sleeve housing as well as the adapter nose 

to make sure the sleeve will be correctly 

positioned into the sleeve housing. 

Sleeve insertion 

: Manually insert the 

sleeve. You will notice on the sleeve & the 

adapters some notches to make sure to 

respect the sleeve insertion direction.

We now advise you to grab TK13OD® tool to 

proceed for installation.

6

Sleeve insertion (2)

: We advise to use the 

TK13OD® to fully push the sleeve into its 

housing.

Tooth assembly 

: Firstly install Turnkey® 

wear cap on top of the adapter, then install 

the tooth on the adapter.

Pin insertion 

: Once the teeth is correctly 

installed on the adapter, insert TK13CL® pin 

into the key hole while respecting the inser-

tion direction (pin head down), then push it 

to the end.

The pin as well as the sleeve have mechani-

cal codings to avoid any incorrect insertion.

 

Pin clamping 

: Once the pin has been 

correctly installed, take TK13 OD® tool 

to screw the pin. Make sure to push the 

pin into the sleeve with the tool before 

screwing and then make a 180° 

counterclockwise pin  turn.

Correct positioning 

: Pin is correctly 

installed when you hear a 

“clac”

 sound 

informing of correct pin lockings.

Correct locking 

: After the “clac” sound, 

the pin will be locked as shown.

The pin rotation is fully completed, the pin 

cannot be turned any further.

FEURST

Boulevard de la Boissonnette  - 42110  - FEURS

Tel : 04.77.27.40.63

Fax : 04.77.27.09.84

Clac !!

30°

Protective caps installation 

: On both teeth 

sides, insert the protective caps to avoid 

fines to fill up the pin hole. (Left cap is 

TK13CPL and right cap is TK13CPR). These 

protective caps will allow you to decrease 

teeth replacement time.

Pin insertion (2)

: Before pin clamping, the 

pin should be in 

“head down”

 position.

Correct locking (2)

: Once the pin has been 

correctly installed and locked, the pin 
should be in 

“head on top”

 position.

1

2

3

7

5

4

8

9

10

11

Reviews: