Page 3
Introduction
Thank you for purchasing the FETtec FC F7. This is a KISS licensed F7 Flight-controller
Features
•
KISS FC v2 firmware (FETtec Alpha FC firmware flashable)
•
F7 Processor
◦
STM32F7RET6 @ 216MHz
◦
MPU6000
•
Supply voltage 6-27V (2S-6S Lipo)
•
Dedicated onboard 5V BEC for VTX (max 600mA)
•
8 pin connector for solder free ESC connection
◦
Connector 1: ESC signal 1-4, telemetry, VCC, GND
◦
Connector 2: ESC signal 5-8 (depending on UAV type 1-4), telemetry, VCC, GND
•
5 UART serials
◦
UART 1 free
◦
UART 2 used for Receiver
◦
UART 3 free
◦
UART 4 used for onboard OSD, can be set free
◦
UART 5 used for ESCs / TLM / Onewire
•
Build-in real Pit-Mode for unify nano (via VTX Pin and 5V on SER1)
•
4 ESC solder pads (Signal/GND) in each corner
•
Direct places for RX and VTX (unify nano, CRSF nano, FrSky R9)
•
Buzzer pads
•
Supported ESC protocols
◦
PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
•
Dimensions 35x30mm without 30x30 corners
◦
20x20mm (with breakable holes M2 to M3)
◦
30x30mm hole distance useable (breakable 30x30mm corners)
•
Overall height: 7,9mm
•
Weight: 5,37g
•
Connector type: JST-SH-1mm
