Go to fetco.com for the latest versions of all information
Page 4
User Guide & Operator instructions
P209
Re0
August 2021
Starting The Brew
1. Turn the power switch “ON”.
2. Prepare a brew basket with the correct size
filter and appropriate amount of tea.
3. Slide the brew basket completely into the
rails.
4. Place a clean, empty, dispenser
under the brew basket.
5. Select a batch & hold the corresponding BREW button in
for 1 second to start
6. -STOP button will illuminate, Brew Selector button will illuminate
-Countdown time will display. Default time setting is 6:45(iced tea)
-Selected BREW button will slowly pulsate to indicate brew is in progress.
-All other BREW buttons for that brew head will be unlit.
7.Dilute DELAY cycle will activate at 3:45
8. Dilute will activate at 3:30.
Upon time out, brewer will return to “READY” for next batch
STOP
button will extinguish and the BREW button will
illuminate on completion
For safety- do not remove brew basket until drip-out is complete.
Enter Programming
There are 7 menu groups-A-F plus EXIT (G).
See the following pages for the batch parameter definitions and all settings for the brewer
TO ENTER PROGRAMMING
1-Turn brewer “OFF” from power switch
2-Turn power switch to “ON”
…Screen will initialize and then
display digital process notifications
3-After Initialization- “STOP” Lamp turns on
4-Quickly press “STOP” button (no need to hold)
When brewer is In PROGRAMMING MODE
-the screen will display:
|BATCH PRG|
|A
(or B-F)
|
-
Illuminated LED indicates active keypad positions
See the following pages for batch parameter definitions
and all settings for the brewer
Enter Programming to Make Changes
Section B –“General Settings” to change tank temperature shown below
Enter Programming-Press
STOP button until the
General Settings (“B”)
screen appears
From the “B” screen
Press button
1
to toggle
to the Tank Temperature
Screen (default is 200°)
From Tank Temp screen
Toggle buttons
2
&
3
to
select the desired
temperature
From Tank Temp screen
Press button
1
to toggle
to the next selection in
General Settings or SAVE
To SAVE and EXIT
Press the
STOP
button to
the “H” screen. Proceed
to screen two below
See the progammin menu layout table on the next page to locate the disired control setings to adjust.
Batch size and menu brewing parameters are in section “A”.
The most common settings for tank temperature satpoint , units of measure are in section “B”.
Tank Temperature
B1
200°F+-
STOP
STOP
Tank Temperature
B1 171° to 207°
STOP
Brew at Temp
B2
YES-
STOP
EXIT
H
NO +
STOP
Brewing
6:45
FETCO
Ready to Brew
STOP BUTTON
↓
ON/OFF switch
is located on
lower right on
back of brewer
STOP
TBS-1221
Ver.
2.0.210317
STOP
Batch Program
A
STOP
STOP
General Settings
B
