2 A
1
2
2
1
2 B
klick
klick
Please note: The machine can only be op
erated under the following conditions [2C]:
Both battery packs are used. Maximum power
with two battery packs (36 V).
Only the lower battery pack is used. Less power
with one battery pack (18 V).
2 C
7.1
Capacity display
The capacity display [1-13] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-11] is pressed:
70‑100%
40‑70%
15‑40%
< 15%
*
*
Recommendation: Charge the battery pack
before any further use.
Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
8
Settings
WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
8.1
Electronics
Smooth start-up
The electronically controlled smooth start-up
function ensures that the power tool starts up
smoothly.
Constant speed
The motor speed is electronically kept con
stant. This ensures a uniform cutting speed
even when under load.
Speed control
You can continuously adjust the speed within
the speed range using the adjusting
wheel [1-12] (see "Technical data"). This ena
bles you to optimise the cutting speed to suit
each surface.
Speed range per material
Solid wood (hard, soft)
6
Chipboard and hardboard
3–6
Laminated wood, blockboard, veneered
and laminated panels
6
Laminate, mineral materials
4–6
English
14
