terlock it. Important: be aware that the
locking engages.
► Replace the top section [2-1] and close the
locking clips [2-2].
Make sure that the filter bag is not pinched
between the top and bottom sections.
7.9
Changing the disposable bag (variants
with AutoClean only)
Removing the disposal bag [6]
► Close off the extractor opening [1-2] using
the sealing plug [1-1].
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Close the disposal bag.
► Remove the disposal bag.
► Dispose of the used disposal bag in accord
ance with statutory regulations.
► Clean the dust container [2-3].
Inserting the disposal bag [7]
► Insert a new disposal bag (ENS-CT26/36/48)
on the inlet nozzle of the container and lock
in position.
Important: The lateral openings on the dis
posal bag must be positioned inside the
container. Make sure that the bolt engages.
► Place the disposal bag over the edge of the
container.
Make sure that the contacts [10-2] are
free.
► Replace the top section [2-1] and close the
locking clips [2-2].
7.10 Volumetric flow monitoring
For safety reasons, an acoustic warning signal
sounds if the air speed in the suction hose falls
below 20 m/s (dust class M only).
The table on the mobile dust extractor ex
plains this connection for the minimum re
quired extraction volume of the respective
hose diameter. If this extraction volume is
not reached, a warning signal sounds.*
* only with EU versions of CT AC
Possible causes
Solution
Value set on the suc
tion power adjust
ment [1-10] is too
low.
Set the suction power
adjustment to a high
er value (see sec
tion 7.4).
Rotary knob [1-9] not
set to the correct
hose diameter.
Set the correct suc
tion hose diameter
(see section 7.1).
Suction hose is
blocked or kinked.
Eliminate the block or
straighten the hose.
Filter bag full.
Insert a new filter bag
(see section 7.7).
Dirty main filter.
Change the main filter
(see section 9.1).
AUTOClean ONLY:
Clean the main filter
(see chapter 8.2).
Electronic monitoring
malfunction.
Have the fault recti
fied by a Festool serv
ice workshop.
Wet extraction.
Function not impaired,
no measures re
quired.
ONLY CTM 36 E AC-
LHS with PLANEX
LHS 2 225:
In tasks that require
a low extraction set
ting (e.g. on soft sur
faces).
Activate bypass func
tion on special extrac
tion sleeve [1A].
8
Working
8.1
Handling
Hose holder: After finishing work, you can feed
the suction hose through the opening [8-2] and
place it in the hose holder.
SysDoc Systainer storage area: A Systainer can
be fastened to the storage area with the four
slides or the T-Loc lock [8-1].
8.2
AutoClean – cleaning the main filter
(variants with AutoClean only)
Only in conjunction with a disposable
bag (to comply with dust class "M"). Not
for use during wet extraction.
English
20