Festool 576777, Original Instructions Manual

Page: 13 / 46

Position 1 = low torque
Position 13 = high torque
There is a signal when the set torque is
reached and the power tool switches off. The
power tool only starts up again if the on/off
switch [1-5] is released and pressed again.
Drilling
Marking shows the drill symbol
= maxi­
mum torque.
9.4
Adjust lighting [1-12]
Configure lighting at the thumbwheel [1-12].
Marking shows position 1 to 13 or drill sym­
bol . The LED light [1-4] automatically
switches on and off with the power tool. The
LED light has an afterglow for a short time after
the tool has been switched off.
Marking shows lighting duration on/
maximum torque. Briefly apply pressure
on the on/off switch [1-5] to permanently
switch the LED light on. After ten minutes, the
LED light automatically switches off.
Marking shows lighting duration off/
maximum torque. The LED light is perma­
nently switched off.
9.5
Impact drilling
Move the selector switch [1-8] to the hammer
symbol
. Set the thumbwheel [1-12] to the
drill symbol .
9.6 Festool Work app
The power tool can be configured with the
Festool Work app.
The battery pack is connected via
Bluetooth
® , see the operating manual for
the battery pack.
10 Tool holder, attachments
WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
Prior to initial use: Apply some multipur­
pose grease to the drill spindle.
10.1 CENTROTEC tool chuck [7]
Fast changeover of tools with CENTROTEC
shaft.
WARNING! Only clamp CENTROTEC tools in
CENTROTEC tool chucks.
Wear gloves when replacing tools.
WH-CE
CENTROTEC ®
klick
1
2
3
4
7
10.2 Chuck [8]
For clamping drill bits and bits with max. shaft
diameter of 1/2" (13 mm).
WARNING! Clamp the tool centrally in the
chuck.
English
13