Festo VMPA...-FB-EPL Series, Electronic Manual

Page: 62 / 232

2. MPA pneumatic modules
2−16
Festo P.BE−CPX−EA−E N en 0705f
2.4 Instructions on commissioning
The reaction of the MPA pneumatic modules can be parame
trized. The tables below give an overview of the parameters
for the MPA pneumatic modules.
Further information on parametrizing can be found in the
system manual or in the manual for the field bus node.
2.4.1 Parameters of the MPA pneumatic modules
The following parameters apply in general to all electronic
modules of the MPA pneumatic modules.
Module parameters: Monitoring the CPX module
Function no. 4828 + m * 64 + 0 m = module number (0...47)
Description Monitoring of the possible faults can be activated or deactivated (suppressed) for
each module separately. Active monitoring causes the following: The fault is:
displayed via the fault LEDs.
sent to the CPX field bus node
Bit
2
Monitoring
Description
Undervoltage of valves (V
VAL
)
[Parameters]
[Monitor Vout/val]
Values 1 = active (presetting)
0 = inactive [Active]
[Inactive]
Remark Monitoring can also be set for the complete CPX terminal (see CPX system manual).
Tab.2/4: Monitoring the CPX module