Fig. 11
3. Then turn the plunger 90° in an anti-clockwise direction up to the stop.
4. Let go of the plunger.
Ä
Valve returns to normal position.
7.2
Teach-in via FMT
The teach-in process must be carried out completely via the FMT (Festo Maintenance Tool
è
The vacuum generator can store 4 parameter sets. In order to manage additional parameter sets, the
individual parameter sets can be stored externally and read in if required.
Requirement
–
Complete system is in normal position
7.2.1
Teach clock cycle
1. Select the parameter set.
2. Set parameter "Teach-In -> Learning mode" to "Time".
3. Set the "Teach-In -> Start" parameter to "active".
4. Actuate "Accept" button.
5. Measure at least one clock cycle.
6. Set the "Teach-In -> Save" parameter to "active".
7. Actuate "Accept" button.
Ä
Values are calculated and transferred.
8. Set the "Teach-In -> Start" parameter to "inactive".
9. Actuate "Accept" button.
10. Actuate the "Update" button.
Ä
Display values are updated.
Operation and use
23
Festo — VABF-S4-...-CB-VH/VL-... — 2019-05
