Festo VABA-S6-1-AP, Operating Instructions Manual

Page: 9 / 14

Festo — VABA-S6-1-AP — 2022-06
Malfunctions
9
Fieldbus startup parameters
ID Parameter Instances Data type Access
1)
Arraysize
20022 Configuration of voltage monitoring
load supply PL
–
0: load voltage monitoring inactive
–
1: load voltage monitoring active,
with suppression of diagnostics at
switch-off (factory setting)
–
2: load voltage monitoring active
1 UINT8 rw –
20052 Response in error status
(communication malfunction)
–
0: reset outputs (factory setting)
–
1: maintain status
1 UINT8 rw –
1) ro = read only; rw = read write
Tab. 7: Fieldbus startup parameters
AP parameter
ID Parameter Instances Data type Access
1)
Arraysize
246 Fieldbus serial number 1 UINT32 ro –
791 Product Key 1 CHAR ro 12
960 Firmware version 1 CHAR ro 30
20000 Module code 1 UINT32 ro –
20085 Measured value of temperature AP-
ASIC [°C] 1 INT16 ro –
20087 Current measured value of logic supply
PS [mV] 1 UINT16 ro –
20088 Current measured value of load supply
PL [mV] 1 UINT16 ro –
20093 Hardware version 1 UINT8 ro –
1) ro = read only; rw = read write
Tab. 8: AP parameter
9 Malfunctions
9.1 Diagnostic messages
All diagnostic messages of the automation system and also information on the grouping and display
of the diagnostic messages
è 1 Applicable documents, Operating instructions automation system
CPX-AP-I.
The table below contains the diagnostic messages of the module.