Festo SFC-LAC CO Series, Manual, Page: 96 / 328

5. Commissioning
5−6
Festo P.BE−SFC−LAC−CO−EN en 0708NH
5.1.3 Before switching on
When switching on the SFC−LAC, the control interface is acti
vated under the default settings [HMI = off ]. If the HME set in
the SFC−LAC (e. g. HME−16−...) is different to the HME actually
connected (e. g. HME−25−...) when commissioning, activation
of the controller by ENABLE or [HMI = on] can lead to an un
expected reaction of the drive (the controller attempts to con
trol a different linear module).
Caution
Unexpected movements of the HME due to incorrect
parameterisation
·
Make sure that there is no active ENABLE signal on the
control interface when switching on the SFC−LAC.
·
Parametrize the entire system completely before
activating the controller with ENABLE or [HMI = on].
5.1.4 SFC−LAC in conjunction with CMXR
Using the SFC−LAC in conjunction with CMXR:
·
Switch the SFC−LAC into the CMXR compatible mode via
the CI or field bus interface (see PNU 150 / 2FF8h).
Using the CI interface: see appendix C.4.