Festo SFC-LAC CO Series, Manual, Page: 87 / 328

4. The control panel (only type SFC−LAC−...−H2−...)
4−17
Festo P.BE−SFC−LAC−CO−EN en 0708NH
4.5.5 [Settings] [Jog mode]
You can use the arrow keys to move the drive continuously
(also possible without previous reference run). The software
end positions have no function here.
4.5.6 [Settings] [CO parameter]
Setting the field bus parameters.
[CO parameter] Parameter Description
[CAN Node ID] 1
Ū
127
(1
Ū
7fh)
Field bus address of the SFC−LAC.
Representation: 1 dec, 1 hex"
Ū
"127 dec, 7f hex"
[CAN Baudrate] 1000 kBd,
800 kBd,
500 kBd,
250 kBd,
125 kBd,
100kBd,
50kBd,
20kBd,
10kBd Field bus baud rate as per settings on master.
[CAN Profile] DS402,
FHPP Profile with which communication between the CAN master and
the SFC−LAC is handled:
DS402: Control takes place as per DS402.
FHPP:
Control takes place as per Festo Handling and
Positioning Profile.
[CAN Volt.Supply] intern,
extern Power supply to the field bus node can take place internally",
i.e. via the logic voltage supply of the SFC−LAC, or externally"
via the field bus (via optocoupler electrically isolated from the
logic voltage of the SFC−LAC), see section 3.6.
Tab.4/6: Menu [Settings] [CAN parameter]
The settings in the menu [CAN parameter] are saved directly
and permanently (including in the event of a power failure) in
the EEPROM after confirmation with OK <Enter>.