Festo SFC-LAC CO Series, Manual, Page: 76 / 328

4. The control panel (only type SFC−LAC−...−H2−...)
4−6
Festo P.BE−SFC−LAC−CO−EN en 0708NH
4.2 The menu system
Accessing the main menu
When the power supply is switched on, the SFC−LAC automati
cally carries out an internal check.
During the first commissioning or when the EEPROM is de
leted, the fault message CAN−BUS INIT NO PARAMETER
ERROR" will appear, as the CAN bus parameters are not
parametrized (see section 5.2.1).
When the device is switched on again, the display will show
briefly the Festo logo then change to the status display.
The
status display
shows the following information:
the type designation of the SFC−LAC
the type of parametrized drive
the position of the drive x
a
= ...
(still without significance when unit is switched on)
the current setting of the device control
(HMI = Human Machine Interface)
The main menu is accessed from the status disply with the
button <Menu>. The currently active button function is
displayed in the lower lines of the LCD display.
CAN–BUS INIT NO
PARAMETER ERROR
Diagnostic <menu>
Config <Enter>
SFC–LAC...
HME...
Xa = 0.00 mm
HMI:off
<Menu>
}
Diagnostic
positioning
Settings
V ESC <Menu>
<––> OK <Enter>
}
HMI control
LCD adjustment
v ESC <Menu>
<––> OK <Enter>