Festo SFC-LAC CO Series, Manual, Page: 103 / 328

5. Commissioning
5−13
Festo P.BE−SFC−LAC−CO−EN en 0708NH
Setting parameters
1. Set the following:
Reference method [Homing method]
Search speed for ascertaining the reference point
[Velocity v_rp]
The positioning speed to the axis zero point
[Velocityv_zp].
2. Accept each setting with OK. <Enter>
In this way the setting will become effective in the drive.
3. Save the parameter settings in EEPROM with the [SAVE...]
menu command. Only then will the settings be retained if
the power supply is switched off or if there is a power
failure.
5.2.4 Activating device control
·
Enable the control panel so that it can control the SFC−LAC
[HMI=on]. This deactivates at the same time the control
interface of the SFC−LAC.
Caution
When control via the control panel or FCT is activated
(HMI: on), the drive
cannot
be stopped with the STOP bit
of the control interface.
When the controller is enabled for the first time with the
ENABLE signal or [HMI=on], the HME−... ascertains its
commutation point (vibrations) for a few seconds.
} Settings
Homing paramet.
Homing method
Velocity v_rp
Velocity v_zp
SAVE...
Diagnostic
positioning
Settings
}
HMI control
LCD adjustment
PLEASE WAIT
COMMUT.–POINT
EVALUATION IS
ACTIVE