Festo SFC-DC series, Manual

Page: 75 / 202

4. Control panel (only type SFC−DC−...−H2−...)
4−13
Festo P.BE−SFC−DC−IO−EN en 0801a
[Axis parameter] Teach mode for setting the axis parameters
Warning
During the teach procedure for specifying the axis zero
point and the stroke limitation, the motor turns or the con
nected drive starts to move.
·
Make sure that nobody can place his/her hand in the
positioning range of the moveable mass and that no
objects lie in its path.
[Axis parameter] Manual
[Zero point] Offset of axis zero point
[SW−limit−neg] Stroke limitation:
Software limit switch, negative
[SW−limit−pos] Stroke limitation:
Software limit switch, positive
[SAVE...] Save parameter in EEPROM
Please note
The set parameters become effective immediately after
confirmation with OK <ENTER>. The settings are saved
permanently in EEPROM with the menu command
[SAVE...]:
·
Save the parameter settings with the menu command
[SAVE]. Only then will the settings be retained even if the
power supply is switched off or if there is a power
failure.