Vision Sensor SBSI/SBSC-EN, 8062650 - 1607b - 13/09/2016
Page 233
Vision Sensor Manual
In the following example the command „SST041000“ (SetShutterTemporary, 04 = number of letters of
shutter value, 1000 = shutter value in microseconds) is sent and the SBS responds with SSTP
(SetShutterTemporary, P = positive). All available telegrams you find in chap.
ff. and are used in analogue way.
Fig. 240: Data output, RS422, tool / 3
5.1.2.1.1 RS422 example 1.1: command Job switch from PC / PLC to SBS
With response / data outputs from SBS
Step 1
Here the same setting for Job and Output are used as in „Ethernet Example 2.1“.
For better traceability in this example the triggered mode and ASCII format is used. That can be done as
follows: Adjust Job/Image acquisition/Trigger mode = Trigger. All other settings remain the same like in
example 1. In Output/Interfaces here the interface RS422 was activated.
For this example Job 1 was set up with the below visible data output:
l
Start: „010“
l
Trailer: „xxx“
Summary of Contents for SBSC-EN
Page 1: ......
