Festo SBOC-M-R1B-H, Manual

Page: 45 / 88

3. Installation
3-9
Festo GDCS-SBOC-EN en 1602a
Connection example The following diagram shows as an example the connection
when the input E1 is used as a trigger input. Observe that:
– The tolerance of 24 V DC ±10 % must be complied with.
– The power supply for the Compact Vision System must be
fused externally with a fast-acting micro fuse, 2 A.
– The residual current of all outputs must not exceed 1.5 A.
– The cable screening must be connected to earth potential
with low impedance.
1
2
3
1
External fuses
2
Trigger input E0 is unused here
3
Cable screening
Fig. 3/2: Example with use of a positive trigger signal at E1
With the configuration software Festo Configuration Tool
(FCT), you determine whether a positive or negative edge
should be used as a trigger signal.