Festo MPA-L Series, Description

Page: 132 / 160

A. Technical appendix
A−4
Festo P.BE−MPAL−EN en 1008NH
General information
Materials
Valves and end plates
Sub−bases and supply plates
Exhaust plate
Silencer
Electronics module
Seals
Threaded rods and clamp strap
Screws Die−cast−AL, PA6, PA6T, PBT
PPA, AW−AL
PA66
PE
CuNi3Si1Mg, PBT, PA66
Elastomer, NBR
Stainless steel, rustproof
Steel, coating ZnNi
Weights (in g):
Multipin end plate
Pneumatic interface
Pneumatic supply plate (with seal, electrical
interlinking module, exhaust plate/flat plate
silencer)
Per sub−base (with seal, electronic module,
electrical interlinking module)
Per 4x sub−base (with seal, electronic module,
electrical interlinking module)
Right−hand end plate without/with lateral
ports
Per valve
Per cover plate
Per pressure regulator plate
130g
approx. 210 g
87 g / 92 g
30g (one v alve position)
113g (four v alve positions)
105 g / 161 g
approx. 56 g
24g
180g
Tab.A/1: General technical data
Note
Valve terminal MPA−L with multi−pin plug connection:
The maximum number of sub−bases that can be confi
gured corresponds to the number of addresses available
(dependent on plug type, see Chapter
1.3)
Valve terminal MPA−L with CPX terminal:
Per valve position one or two solenoid coils and within
the valve terminal MPA−L maximum 32 solenoid coils
can be controlled via the CPX terminal.