Festo MPA-FB Series, Manual

Page: 122 / 168

5. Diagnosis and error treatment
5−26
Festo P.BE−MPA−EN en 0502b
MPA valve terminal with CPX terminal
Removing the CPX pneumatic interface:
from the sub−base of the MPA valve terminal is described
in appendix B.
from the CPX terminal is described in the CPX system
manual.
MPA valve terminal with MP or MPM connection
Removing Proceed as follows:
1. Loosen the electrical and pneumatic connections and re
move the MPA valve terminal from its fastening surface
(see this chapter "Dismantling the MPA valve terminal").
2. Place the MPA valve terminal on a flat working surface.
3. MP connection:
Loosen and remove the board with the multipin plug in
the MP sub−base (position of the fastening screws see
diagram).