Festo MPA-ASI Series, Manual

Page: 61 / 208

2. Fitting
2−7
Festo P.BE−MPA−EN en 0802c
Variant Fastening points
1
1
MPA−S valve terminal with CPX terminal
2
Necessary fastening of the hat
rail clamping units:
in the end plates:
each with an M4 screw
1
in the pneumatic interface:
with an M4 screw
2
1
MPA−S valve terminal with multipin connection
1
Necessary fastening of the hat
rail clamping units:
In the right−hand end plate
and in the multipin sub−base:
each with an M4 screw
1
Tab.2/2: Necessary fastening points for the hat rail fitting
Fitting Proceed as follows:
1. Make sure that the fastening surface can support the
weight of the MPA−S valve terminal (weights see
appendixA, Tab.A/1).
2. Fit the hat rail (support rail EN 60715 35x7.5;
width 35 mm, height 7.5 mm). Make sure there is
sufficient space for connecting the supply cables and
tubing.
3. Fasten the hat rail to the fastening surface at intervals of
approx. every 100 mm.