Festo MPA-ASI Series, Manual

Page: 197 / 208

B. Supplementary component summary
B−11
Festo P.BE−MPA−EN en 0802c
B.2 Separating the MPA−S valve terminal from the CPX terminal
The MPA−S valve terminal is connected to the CPX terminal by
means of a pneumatic interface (see following figure).
1
CPX terminal
2
Pneumatic
interface
3
MPA−S valve
terminal
1 2 3
Fig.B/1: Pneumatic interface
Dismantling Proceed as follows:
1. Loosen the electrical and pneumatic connections and
remove the MPA−S valve terminal from its fastening
surface (see chapter 5, Dismantling the MPA−S valve
terminal").
2. Loosen the fastening screws between the pneumatic
interface and the MPA sub−base in the sequence
3
,
2
,
1
(see Fig.B/2).
3. Then loosen the fastening screws.