Festo MPA-ASI Series, Manual

Page: 167 / 208

5. Maintenance and conversion
5−39
Festo P.BE−MPA−EN en 0802c
Necessary components
For extension you will require:
Components Type
One of the following electric MPA supply plates:
with M18 plug, (3−pin)
with 7/8" plug, (4−pin)
with 7/8" plug, (5−pin)
VMPA−FB−SP−V
VMPA−FB−SP−7/8−V−4POL
VMPA−FB−SP−7/8−V−5POL
Also a seal without channel separation or an isolating seal
with channel separation
See Tab.1/8
Tab.5/11: Electric supply plates
Fitting Proceed as follows:
1. Loosen the electric and pneumatic connections and
remove the MPA−S valve terminal from its fastening
surface (see section 5.2).
2. Fit the electric supply plate in accordance with the specifi
cations in the mounting instructions VMPA−FB−SP−...−...
5.4.5 Adding a pressure sensor plate
Necessary components
For extension you will require:
Components Type
One of the following pressure sensor plates:
For displaying the operating pressure in channel 1
For displaying the pressure in exhaust channels 3 and 5
For displaying an external pressure (P1)
VMPA−FB−PS−1
VMPA−FB−PS−3/5
VMPA−FB−PS−P1
Also a seal without channel separat. or an isolating seal with channel separation See Tab.1/8
Tab.5/12: Pressure sensor plates