Festo MPA-ASI Series, Manual

Page: 166 / 208

5. Maintenance and conversion
5−38
Festo P.BE−MPA−EN en 0802c
Fitting Proceed as follows:
1. Fit the new sub−base and, if necessary, another pneumatic
supply plate (see section 5.3.6).
2. Only MPA−S valve terminal with multipin connection:
If the new sub−base added is the last one in front of the
right−hand MPA end plate, you must insert the end piece
type MPA into the last manifold board (see Fig.5/17).
3. Fit the valve plates or blanking plates onto the empty
valve locations (see section 5.3.3).
4. Mount the MPA−S valve terminal on the fastening surface
(see chapter 2 Fitting onto a wall" or Fitting onto a
hatrail").
5. Then fit the pneumatic and electrical connections
(seechapter 3 Installation, connecting the MPA−S valve
terminal").
Note
If a sub−base is inserted between existing sub−bases, the
address assignment of all the valves to the right of the
inserted sub−base will be shifted.
5.4.4 Adding an electric supply plate
The electric supply plate is intended for the intermediate
supply of load voltage for the valves.