Festo MPA-ASI Series, Manual

Page: 156 / 208

5. Maintenance and conversion
5−28
Festo P.BE−MPA−EN en 0802c
MPA−S valve terminal with multipin connection
Dismantling Proceed as follows:
1. Loosen the electrical and pneumatic connections and
remove the MPA−S valve terminal from its fastening
surface (see this chapter Dismantling the MPA−S valve
terminal").
2. Place the MPA−S valve terminal on a flat working surface.
3. Loosen the fastening screws between the multipin
sub−base and the pneumatic sub−bases in the sequence
3
,
2
,
1
(see following diagram).
4. Then loosen and remove the fastening screws.
1
2 3
Fig.5/13: Position of the screw connectors on the sub−base
5. Pull the multipin sub−base away from the pneumatic
sub−bases.