Festo EXCM-10-***-E, Translation Of The Original Instructions

Page: 56 / 84

6 Operation
56 Festo – EXCM-10/-30-...-E-EN – 1612b – English
Confirmation (acknowledge)
Byte Description Remedy
0x00 Everything OK. –
0x01 Service is not supported. Check the service ID of the request.
0x03 User data length of the request is invalid. Check the structure of the request.
0xA0 Range of values of another CVE object violated. Correct range of values.
0xA2 Invalid object index. Correct the object index.
0xA4 The CVE object cannot be read. –
0xA5 The CVE object cannot be written. –
0xA6 The CVE object cannot be written while the drive is
in an “Operation enabled” status.
Quit the “Operation enabled” status.
0xA7 The CVE object must not be written without master
control.
Setting and releasing the control
interface in the FCT.
0xA9 The CVE object cannot be written, as the value is
lower than the minimum value.
Correct the value.
0xAA The CVE object cannot be written, as the value is
greater than the maximum value.
Correct the value.
0xAB The CVE object cannot be written, as the value is
not within the valid value set.
Correct the value.
0xAC The CVE object cannot be written, as the specified
data type is incorrect.
Correct the data type.
0xAD The CVE object cannot be written, as it is password
protected.
Remove password protection via FCT.
0xE0 Control interface is blocked by FCT. Enabling the control interface in the
FCT.
Tab. 6.17 Confirmation (acknowledge)