EHMB
10
Festo – EHMB – 2019-05c English
To guarantee the switching function of the proximity sensor:
Set proximity sensor (E) so that there is a gap of X = 0.5 mm to
the cams.
Mount each proximity sensor using the supplied lock nut (tight
ening torque of the lock nuts
è
Operating instructions of the
proximity sensor).
Fig. 8
(E)
To install additional trip cams (
è
Catalogue specifications,
è
www.festo.com/catalogue).
Installing additional trip cams:
–
Insert cam (C) into the cut-out on the groove of the fixture.
For the EHMB-32, this requires removal of the sensor brack
et (tightening torque when reattaching: 1.2 Nm).
–
Swivel cam (C) either upwards or downwards.
–
Insert additional cams into the cut-out as needed.
Fig. 9
(C)
(D)
