DRRD-12 ... 63
Festo – DRRD-12 ... 63-Z6 – 1310b English
23
6
Commissioning
Warning
Danger of injury from rotating loads.
•
Make sure the DRRD is only set into motion with protective devices.
•
Make sure that in the swivel angle of the DRRD
–
Nobody can reach in
–
No foreign objects can enter
(e.g. by means of an individual protective guard).
Note
•
Make sure that the following requirements are observed:
–
the shock absorbers are secured with lock nuts
–
the operating conditions are within the permissible ranges
–
the assembly instructions for the DRRD-...-Y12 are observed.
6.1
Commissioning end-position adjustment
1. Rotate both upstream one-way flow control
valves (A):
–
at first completely closed
–
then open them again approximately one
turn.
2. Pressurize the drive optionally in one of the
following ways:
–
slow pressurisation of one side
–
simultaneous pressurisation of both sides
with subsequent venting of one side.
(A)
Fig. 7
Note
Risk of damage!
If the shock absorber is unscrewed too far, it will result in the piston colliding with the
end cap with insufficient cushioning.
•
Observe the permissible shock absorber settings (
Tab. 4).
3. Pressurize the corresponding port to swivel
the DRRD into the desired end position.
4. Loosen the lock nut on the shock absorber.
Fig. 8
Summary of Contents for DRRD-35
Page 75: ...DRRD 12 63 Festo DRRD 12 63 Z6 1310b 75 3 12 20 10 12 HEL...
Page 78: ...DRRD 12 63 78 Festo DRRD 12 63 Z6 1310b 5 2 GRLA Fig 5 HGL VZS 5 3 A 9 10 9 Fig 6 A 9...
Page 85: ...DRRD 12 63 Festo DRRD 12 63 Z6 1310b 85 10 www festo com catalogue 11 DRRD Festo 10 9 Tab 8...
