DRRD-12 ... 63
Festo – DRRD-12 ... 63-Z6 – 1310b English
19
3
Requirements for product use
Note
Malfunction and material damage due to incorrect handling.
•
Always comply with the specifications of this chapter.
This is the only way to ensure correct and safe product behaviour.
•
Take into consideration the legal regulations applicable for the destination, as well as:
–
regulations and standards
–
regulations of the testing organizations and insurers
–
national specifications.
•
Note the warnings and instructions on the product and in the relevant operating instructions.
•
Remove all transport packaging, such as transparencies, caps and cartons
(with the exception of any covers in the pneumatic ports).
The packaging is intended for recycling
(exception: oil paper = residual waste).
•
Take into account the material specifications (
12 Technical data).
•
Use the product in its original status, without any unauthorised product modifications.
•
Take into consideration the ambient conditions at the location of use.
Corrosive elements in the environment (e.g. ozone) will reduce the service life of the product.
•
Compare the limit values specified in these operating instructions with your actual application
(e.g. pressures, forces, torques, temperatures, masses, speeds).
Operation of the product in compliance with the relevant safety regulations is contingent on adher-
ence to the load limits.
•
Take the tolerance of the tightening torques into account. Unless otherwise specified, the tolerance
is ± 20 %.
•
Do not modify any screws or threaded pins unless this is directly requested in these instructions. For
safety reasons, they are fixed with screw locking agent.
For vertical installation:
•
Make sure the drive reaches a stable position when it comes to rest
(e.g. the lowest point or a variant with clamping unit
10 Accessories).
•
Make sure the compressed air is properly prepared (
12 Technical data).
•
Having selected a medium, stick with it for the entire life of the product
(e.g. always use unlubricated compressed air).
•
Pressurize your entire system slowly.
There will then be no uncontrolled movements.
For slow start-up pressurisation, use start-up valve type HEL.
Summary of Contents for DRRD-35
Page 75: ...DRRD 12 63 Festo DRRD 12 63 Z6 1310b 75 3 12 20 10 12 HEL...
Page 78: ...DRRD 12 63 78 Festo DRRD 12 63 Z6 1310b 5 2 GRLA Fig 5 HGL VZS 5 3 A 9 10 9 Fig 6 A 9...
Page 85: ...DRRD 12 63 Festo DRRD 12 63 Z6 1310b 85 10 www festo com catalogue 11 DRRD Festo 10 9 Tab 8...
