Festo CPV10, Manual

Page: 114 / 164

5. Maintenance and conversion
5−14
Festo P.BE−CPV−EN en 0503g
·
The new one−piece flat seal is no longer glued onto the
bottom of the electric sub−base, but simply on the ter
minal lugs of the valve solenoid coils (see diagram).
1
New flat seal
1
Fig.5/5: Flat seal
·
Place the connector cover onto the terminal lugs of the
valve block. Carefully press down the connector cover.
·
Tighten the screws on the electric sub−base in diagonally
opposite sequence with 0.75 ± 0.15 (CPV10/14) or 3Nm
(CPV18).
With CPV valve terminals with relay plates
·
Fit the connector plugs onto the relay outputs as de
scribed under Connecting current−consuming devices to
the relay plate" in chapter 3.