Festo CP Factory, Original Operating Instructions

Page: 50 / 90

Commissioning
50
© Festo Didactic 8065842 en
7.4.3 Pneumatic connection from application modules to basic module CP Lab Conveyor
(option – not available at all application modules)
The pneumatic connection is based on the principle of the following sketch. The application module is
connected from the valve terminal to the shut-off valve (2) on the conveyor belt. The hose (1) (nominal width
4) is simply inserted into the QS connector. The supply line (5) is plugged into the T-plug (3)
The CP Lab Band is also supplied with a T-connector (4).
Pneumatically connect application module / illustration similar