4. Instructions on commissioning
Festo GDCP-CMXR-C2-HW-EN 1002NH
47
4.
Instructions on commissioning
4.1
General instructions for commissioning
The multi-axis control system CMXR-C2 is configured and commissioned using the
appropriate software.
Information on this can be found in the online help for the software
as well as in the associated system description.
The firmware and the respective applications are stored on a memory card, which must be
inserted in the slot of the central control unit before operation can commence.
4.2
Performance of the central control unit
4.2.1
Running up performance
The running up performance is divided into the following three main sections:
-
Running up of the boot block
-
Running up of the firmware
-
Running up of the application.
The running up progress is shown in the 7-segment display.
-
Numbers > 0 signal the progress during the running up of the boot system and the
control system firmware.
-
Special characters and letters (e.g. L, II, ...) describe the running up of the application
or various operating states of the device.
-
An error display will be activated if errors are detected during the running up. Errors
are displayed parallel to the states. The status is displayed here initially and is
subsequently displayed in alternation with the two or three-digit error number
(e.g. “-,0,-,E,1,0”). Each character is displayed for one second.
Summary of Contents for CMXR-C2
Page 2: ......
Page 5: ...Festo GDCP CMXR C2 HW EN 1002NH 5...
Page 56: ...6 Maintenance and care 56 Festo GDCP CMXR C2 HW EN 1002NH...
