5.
NOTICE!
Unpredictable behaviour of the machine when the device is restarted.
Depending on the device, a restart (reboot) may be required to complete the following functions.
A safety note is displayed before the restart.
•
Only acknowledge the safety note once you have ensured that any unpredictable or unexpec-
ted behaviour of the connected machine cannot cause any damage.
Ensure that any unpredictable behaviour by the device cannot cause any damage. Confirm mes-
sage with "Ok".
Ä
The network settings are changed.
Disconnecting the device
The "Disconnect" button is visible when the plug-in is connected to a device.
The connection to the device is disconnected by actuating the "Disconnect" button. If there are any
unsaved changes when the device is disconnected, a message appears to notify users that parameter
changes will be lost if there is a power failure or after a restart. Users then have the option to save the
changes on the device before it is disconnected or to continue with the disconnection process without
saving the changes.
2.2.2.3
Synchronising device data
While the connection is being established, a check is run to ensure that the defined device data of the
plug-in are compatible with the connected device, e. g. when establishing the connection with the IP
address of a device. If non-conforming data are found, the non-conformity is displayed. The connec-
tion is not established until the non-conformity is corrected.
Fig. 6 Message for synchronising the device data
2.2.2.4
Synchronising the configuration and parameters
Before the connection is established, a check is run to determine whether parameterisation and con-
figuration in the project match that of the device. If there are deviations between the project and the
device, invalid parameters are shown so that they can be corrected.
CMMT-ST Plug-in
31
Festo — CMMT-ST-SW — 2019-02
Summary of Contents for CMMT-ST-SW
Page 615: ......
